Maytag MSD2650HEB Use and Care Guide - Page 9
Installing, Front-Mounted, Handles, Stainless, Steel, Removing
View all Maytag MSD2650HEB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Installation Installing Front-Mounted Stainless Steel Handles for 1. Loosen lower door clip on door with '/4" hex nut driver. 2. Locate predrilled hole at base of handle, and fit hollow end of handle over lower door clip. Removing Front-Mounted Stainless Steel Handles for 1. Remove plastic button plug at base of handle with a very small flat-blade screwdriver. • Insert '/4" hex nut driver into predrilled hole to remove screw. 2. Slide handle down and remove from bottom door clip. 3. Repeat above steps to remove other handle. 3. Fit other end of handle over upper door clip and slide up as far as possible. NOTE: If top of handle does not fit over top clip, loosen lower clip further until fit can be accomplished. 4. Insert '/_" hex nut driver into predrilled hole at base of handle to tighten screw. Insert screw plug into hole, as illustrated. 5. Repeat above steps to install other handle.