Maytag MVWC700VW Installation Instructions - Page 4

[] Do not ground to a gas pipe. [] Check with a qualified electrician if you are not sure the washer is properly grounded. [] Do not have a fuse in the neutral or ground circuit. Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. m A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit serving only this appliance be provided. m This washer is equipped with a power supply cord having a 3 prong grounding plug. m To minimize possible shock hazard, the cord must be plugged into a mating, 3 prong, grounding-type outlet, grounded in accordance with local codes and ordinances. If a mating outlet is not available, it is the personal responsibility and obligation of the customer to have the properly grounded outlet installed by a qualified electrician. [] If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate. GROUNDING INSTRUCTIONS For a grounded, cord=connected washer: This washer must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of electrical shock by providing a path of least resistance for electric current. This washer is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. WARNING: Improper connection of the equipmentgrounding conductor can result in a risk of electric shock. Check with a qualified electrician or serviceman if you are in doubt as to whether the appliance is properly grounded. Do not modify the plug provided with the appliance -if it will not fit the outlet, have a proper outlet installed by a qualified electrician. For a permanently connected washer: This washer must be connected to a grounded metal, permanent wiring system, or an equipment grounding conductor must be run with the circuit conductors and connected to the equipment-grounding terminal or lead on the appliance. INSTALLATIONINSTRUCTIONS Excessive Weight Hazard Use two or more people to move and install washer. Failure to do so can result in back or other injury. NOTE: To avoid floor damage, set the washer onto cardboard before moving across floor. Removing the shipping material is necessary for proper operation. If the shipping material is not removed, the washer will make excessive noise. 1. Move the washer to within approximately 3 ft (90 cm) of its final location. 2= The washer must be in the upright position and not tilted before removing the shipping material. 3. Locate the yellow shipping materials on the rear of the machine, near the bottom. Follow the steps for your particular model, either the one with the straight power cord and cord restraint or the looped power cord version. 4