Meade TE346W User Manual - Page 12

SETTING THE ICE WARNING ALARM (PRE-AL) If Weekday (W) or Single day (S) alarm is MODE, the Ice Warning Alarm (Pre-AL) can be programmed. • Press ALARM button once to enter into the Ice Warning Alarm setting mode. The abbreviation OFF with a PRE-AL next to it will be displayed. • Press and hold ALARM button for two seconds. The number 30 will flash, meaning that if selected, the alarm will sound 30 minutes earlier than the Weekday or Single alarm. • Select the desired Ice Warning Alarm interval in 15 minutes increments between 15 and 90 minutes, using UP (? ) or DOWN (? )buttons • Press ALARM button to confirm and exit from the alarm setting mode. ACTIVATING/ DEACTIVATING ALARMS • Press ALARM button to enter into the desired alarm mode. • Press UP ( ? ) to activate alarm and the corresponding icons W, S or PRE-AL will be displayed. • Press DOWN ( ? ) to deactivate alarm until "OFF" is displayed. MAINTANANCE • Do not mix old and batteries. CHANGING BATTERIES • If the low battery indicator lights up, replace batteries in the corresponding unit. CLEANING The main unit and remote sensors housings can be cleaned with a damp cloth. Small parts can be cleaned with a cotton tip or pipe-cleaner. Never use abrasive or corrosive cleaning agents or solvents. Do not immerse electronic components in water. TROUBLESHOOTING Check here before contacting customer service. Issue Symptom Solution Main unit US Atomic Time Place unit by the window and keep it there signal is not overnight received Cannot locate remote sensor Remote sensor Check batteries Check location Press and hold DOWN ( ? ) button on the main unit to search for the signal form the remote sensor Data does not Initiate manual sensor search (Press and hold match data on the DOWN ( ? ) button on the main unit) main unit 12