Meade TE346W User Manual - Page 7

A. WEATHER/ OUTDOOR TEMPERATURE window B. INDOOR TEMPERATURE/ HUMIDITY window C. CLOCK window D. DOWN (? ) button • Select the next available mode • Press and hold for 2 seconds to search for wireless signal from remote sensor. • Decrease parameters. E. UP ( ? ) button • Press to select the next available mode • Increase the parameters • In time with seconds display mode, press and hold for 2 seconds to activate/ deactivate atomic time signal search manually. • In time with weekday display mode, press and hold for 2 seconds to switch time zone from Pacific, Mountain, Central to Eastern. F. MODE button • When time mode has been selected, press once to toggle between time with seconds display or time with weekday display. • Press and hold for 2 seconds, set language of the day of the week, year digit, month digit, date digit, hour format (12/ 24 hours), hour digit and minute digit. (Note: calendar format is default in month-date display) • When indoor temperature and humidity mode has been selected, press and hold for 2 seconds to toggle the temperature unit between Celsius or Fahrenheit. G. ALARM button • When time mode has been selected, press once to display the alarm time of weekday alarm (W), single alarm (S) and pre-alarm (Pre-AL). • Hold for 2 seconds, set weekday, single or pre-alarm's alarm time. • When indoor temperature and humidity mode has been selected, press once to display the highest or lowest temperature alarm's value. • Hold for 2 seconds, set the highest or lowest temperature alarm's value. • When alarm is on, press once to stop the alarm temporarily. H. MEM button • When indoor temperature and humidity mode has been selected, press to recall the minimum or maximum temperature and humidity readings of main and remote units. • Press and hold for 2 seconds, collected memories will be cleared. I. CHANNEL button • Press to display the outdoor temperature readings of Channels 1, 2 and 3. (additional remote sensors are required) • Hold for 2 seconds, enter into the circulation mode and outdoor temperature readings of Channels 1, 2 and 3 will be displayed automatically in every 5 seconds. J. WALL- MOUNT holes • Use 2 provided screws to mount the unit on a wall K. BATTERY COMPARTMENT • Accommodate two (2) CR2032 batteries L. TABLE STAND 7