Memorex Mi1111 User's Manual - Page 9
Power Source
UPC - 749720012879
View all Memorex Mi1111 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
POWER SOURCE AC CONNECTION Unwind the AC cord and extend it to its full length. Insert the AC plug into any convenient 120V 60Hz household outlet. Please note that this unit is equipped with a polarized AC plug which has one blade wider than the AC Outlet other. This is a safety feature to reduce the likelihood of electric shock. This polarized AC plug will only fit in a AC Plug polarized AC outlet. If you find that you cannot insert this plug into your outlet, you may have an obsolete non-polarized outlet. Please do not try to defeat this safety feature by using a non-polarized adapter or by filing the wider blade to make it fit into your outlet. If this plug does not fit into your outlet, you should contact a qualified licensed electrician to replace your obsolete outlet. IMPORTANT NOTE: If there is a power failure or the AC cord is disconnected for a short period of time, the clock will stop but the time and radio presets will be saved. When the power is resumed or the AC cord is connected again, the clock time will continue running and the radio presets will have been saved. However, if the power failure lasts or the AC cord is disconnected for several minutes, the clock will be reset ("- -:- -" will blink in the display) and you will need to set the clock and radio presets again. REMOTE BATTERY INSTALLATION 1. Remove the Battery Compartment (on the bottom rear of the remote control) by sliding the compartment out. (You can insert a penny, or similar object, into the groove on the compartment to help slide it out.) 2. Install a CR2025 battery, paying attention to the polarity diagram in the Battery Compartment (positive side up). 3. Replace the Battery Compartment. BATTERY PRECAUTIONS Follow these precautions when using a battery in this device: 1. Warning - Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. 2. Use only the size and type of battery specified. 3. Be sure to follow the correct polarity when installing the battery as indicated in the Battery Compartment. A reversed battery may cause damage to the device. 4. If the device is not to be used for a long period of time, remove the battery to prevent damage or injury from possible battery leakage. 5. Do not try to recharge a battery not intended to be recharged; it can overheat and rupture. (Follow battery manufacturer's directions.) 8