Metabo WPB 13-125 Quick DS Operating Instructions - Page 11

ENGLISH en .../min...... revolutions per minute rpm ......... revolutions per minute alternating current alternating current /direct current n rated speed The "C" and "US" indicators adjacent to the CSA Mark signify that the product has been evaluated to the applicable CSA and ANSI/ (a) UL Standards, for use in Canada and the U.S., respectively. 4. Overview mmaaxx.. 66..66 llbbss The metal eye (a) is designed for attaching suitable fall protection. The tether used, including carabiner, must have a minimum breaking force (MBF) of 15 kN (3300 lbs) and may not be longer than 2 m (6 ft). WEPB 17-125 Quick DS, WEPB 17-150 Quick DS: The tether used, including mmiinn.. 1100 kkNN mminin. 2. 2242848ft.llbbss carabiner, must have a minimum breaking force (MBF) of 10 kN (2248 lbs) and max. 22m max. 6 ft may not be longer than 2 m (6 ft). The operating manual for the fall protection must be observed. Regularly check the machine (in particular the area of the metal eye) and the fall protection used for any damage. See page 2. 1 "Quick"clamping nut * 2 Spindle 3 Auobalancer support flange * 4 Spindle locking button 5 Sliding on/off switch * 6 Handle 7 Electronic signal indicator * 8 Thumbwheel for selection of speed * 9 Trigger switch * 10 Transport eyelet, for WEPBA 17-125 Quick, WEPBA 17-150 Quick (Use only to transport the machine)* 11 Paddle switch * 12 Additional handle/Additional handle with vibration damping * 13 Safety cover 14 Support flange 15 2-hole nut * 16 2-hole spanner * 17 Lever for safety guard attachment * depending on equipment/not in scope of delivery Attach the tether and its carabiner to the metal eye (a). 5. Commissioning Fasten the other end of the tether outside the working area so that the falling machine is held securely. Do not fasten to the person or to movable elements. There must be sufficient distance to the working position. Attach the fall protection such that the machine moves away from the operator if it falls. Ensure that nobody is in the danger area. Before using the tool, check to make sure that the rated mains voltage and mains frequency, as stated on the rating label, correspond to your power supply. Always install an RCD with a maximum trip current of 30 mA upstream. The maximum possible fall height must not exceed 2 m (6 ft). 1x Service! After a fall, the be tagged and machine must removed from service, and checked by a recognized expert. Symbols on the tool Class II Construction V volts A amperes Hz hertz W watts max. diameter of the accessory 5.1 Attaching the additional handle Always work with the additional handle (12) attached! Attach the additional handle on the left or right of the machine and secure. 5.2 Attach the safety guard For safety reasons, always use the safety guard provided for the respective wheel! See also chapter 10. Accessories! Safety guard for grinding Designed for work with roughing wheels, flap sanding pads, diamond cut-off wheels. See illustration D on page 2. - Push and hold the lever (17). Place the safety guard (13) in the position indicated. 11