Miele DA 249 Operating manual - Page 17

Cleaning and Care ,WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Before cleaning or servicing the hood, disconnect it from the power supply, see "Important Safety Instructions". ,The halogen bulbs are very hot when in use. They stay hot for some time after turned off. Use caution, danger of burns. Wet cleaning the hot bulbs will cause damage. Wait a few minutes after turning them off before cleaning. Cleaning the casing Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. They will damage the surface. Avoid: - cleaning agents containing soda, acids, solvents or chlorides, - abrasive cleaning agents e.g. powder or cream cleansers, - abrasive sponges, e.g. pot scourers or sponges which have been previously used with abrasive cleaning agents. - limescale removers These will damage the surface. The following instructions for cleaning "Stainless steel" surfaces and "Stainless steel colored controls" should be followed in addition to the general "Cleaning the casing" instructions. Stainless steel Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can also be used. Apply sparingly with even pressure. ^ All external surfaces and controls can be cleaned with a mild solution of warm water and liquid dish soap applied with a soft sponge. ^ Wipe dry using a soft cloth. Do not use too much water when cleaning the controls. Water could penetrate into the electronics and cause damage. Stainless steel colored controls These controls may become discolored or damaged if not cleaned regularly. Do not use a stainless steel cleaner on these controls. ^ Glass surfaces can be cleaned using glass cleaner. 17