Miele Dynamic U1 Jazz - SHCE0 Operating instructions - Page 22

en-US  Raise the vacuum cleaner into the vertical position.  Press the release button on the telescopic wand to detach the suction hose handle (Fig. 17).  For increased stability, turn the elbow joint at the bottom of the hose downwards as illustrated until it clicks into position above the retainer (Fig. 18).  Unlock the hose connector by turning it in the direction of the arrow (Fig. 34).  Now detach the hose connector from the elbow by pulling it (Fig. 34).  Remove any debris or blockages.  Replace the connector, making sure it goes on straight. Lock it into position. If you unable to reach all of the debris, you can also try the following steps: Unlock the service cover at the back of the vacuum cleaner as follows (Fig. 35).  Using a coin, turn the two screws as far as they will go.  Pry the cover off.  Remove any debris or blockages.  Reinsert the service cover and lock it using the screws. Cleaning and care  Always disconnect the vacuum cleaner from the electrical supply before cleaning it. Turn off and unplug it. Vacuum cleaner and accessories The vacuum cleaner and all plastic accessories can be cleaned with a proprietary cleaner suitable for plastic.  Do not use abrasive cleaning agents, glass cleaning agents, allpurpose cleaners or oil-based conditioning agents! Dust compartment The dust compartment can, if necessary, be cleaned using a dry duster, brush or, if available, a second vacuum cleaner to vacuum the dust out. Monitor the filter bag change indicator and inspect all filters regularly. Clean or replace them when necessary according to these Operating Instructions.  Do not let the vacuum cleaner get wet. If moisture gets into the appliance, there is a risk of electric shock. 22