Miele K 1911 Vi Operating and Installation manual - Page 51
Securing an alternative anti-tip, device, Select screws according to
![]() |
View all Miele K 1911 Vi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Installing the appliance Securing an alternative anti-tip device If the anti-tip brackets cannot be attached securely, an alternative anti-tip device can be used. Ensure that there is no "give" between the appliance and the anti-tip device. If possible, always screw the wooden beam to existing studs. - The beam must cover the appliance by at least 2" (50.8 mm). ^ Mark the installation height (lower edge of the beam) on the rear wall of the niche. ^ Select screws according to the thickness of the wooden beam. Example: 3 ½" (89 mm) screw for 2x4 beam. ^ Determine the number of screws based on the cavity width, to ensure that the beam will be attached securely. ^ Locate wall studs near the rear wall of the cavity and mark drill holes in the beam. ^ Pre-drill the wooden beam. ^ Attach the wooden beam to the rear wall of the niche. - Cut a wooden beam (cross section min. 3" x 4" [75 mm x 100 mm] to the required length). - The length is equal to the width of the installation niche. - If the installation niche is deeper than the appliance, select a beam with a larger cross section, or attach two beams. 51
![](/manual_guide/products/miele-k-1911-vi-operating-installation-manual-36366d3/51.png)