Motorola DS6708-DL20291ZZR Reference Guide - Page 41
Maintenance & Technical Specifications, Cancel, Set Synapse Defaults - programming bar codes set defaults
View all Motorola DS6708-DL20291ZZR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Maintenance & Technical Specifications 3 - 3 Table 3-1 Troubleshooting (Continued) Problem Possible Causes Possible Solutions Digital scanner decodes bar code, but does not transmit the data to the host. Digital scanner is not programmed for Scan the appropriate host type the correct host type. programming bar code. See the chapter corresponding to the host type. Interface cable is loose. Re-connect the cable. If 4 long low beeps are heard, a transmission error occurred. Set the digital scanner's communication parameters to match the host's setting. If 5 low beeps are heard, a conversion Configure the digital scanner's or format error occurred. conversion parameters properly. If low/high/low beeps are heard, an invalid ADF rule is detected. Program the correct ADF rules. If high/low beeps are heard, the digital Normal scanning a Code 39 bar code scanner is buffering Code 39 data. and the Code 39 Buffering option is enabled. Host displays scanned data incorrectly. Digital scanner is not programmed to Scan the appropriate host type work with the host. programming bar code. For RS-232, set the digital scanner's communication parameters to match the host's settings. For a Keyboard Wedge configuration, program the system for the correct keyboard type, and turn off the CAPS LOCK key. Program the proper editing options (e.g., UPC-E to UPC-A Conversion). Digital scanner emits high/high/high/low beeps when not in use. RS-232 receive error. Normal during host reset. Otherwise, set the digital scanner's RS-232 parity to match the host setting. Digital scanner emits low/high beeps during programming. Input error or Cancel bar code was scanned. Scan the correct numeric bar codes within range for the parameter programmed. Digital scanner emits low/high/low/high beeps during programming. Out of ADF parameter storage space. Erase all rules and re-program with shorter rules. The digital scanner may be out of Synapse parameter storage space. Scan Set Synapse Defaults bar code for cables no longer in use and re-program the digital scanner for the current host interface.