Motorola DS6708-DL20291ZZR Reference Guide - Page 48

4 - 2 Symbol DS6708 Digital Scanner Product Reference Guide Scanning Sequence Examples In most cases, scanning one bar code sets the parameter value. For example, to set the beeper tone to high, scan the High Frequency (beeper tone) bar code listed under Beeper Tone on page 4-6. The digital scanner issues a fast warble beep and the LED turns green, signifying a successful parameter entry. Other parameters, such as Serial Response Time-Out or Data Transmission Formats, require scanning several bar codes. See these parameter descriptions for this procedure. Errors While Scanning Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter. User Preferences/Miscellaneous Options Parameter Defaults Table 4-1 lists defaults for user preferences parameters. There are two ways to change the default values: • Scan the appropriate bar codes in this guide. These new values replace the standard default values in memory. To recall the default parameter values, scan the Set Default Parameter on page 4-4. • Configure the digital scanner using the 123Scan configuration program (see Chapter 12, 123Scan). NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and miscellaneous default parameters. Table 4-1 User Preferences Parameter Defaults Parameter Parameter Number User Preferences Set Default Parameter Parameter Scanning ECh Beeper Tone 91h Beeper Volume 8Ch Power Mode 80h Time Delay to Low Power Mode 92h Trigger Mode 8Ah Picklist Mode F0h 92h Presentation Mode F1h, 74h Decode Session Timeout 88h Timeout Between Decodes, Same Symbol 89h Default Restore Defaults Enable Medium High Continuous On 1 Minute Auto Aim Disabled Always 3 Sec 9.9 Sec 0.6 Sec Page Number 4-4 4-5 4-6 4-7 4-7 4-8 4-9 4-10 4-11 4-13 4-13