Motorola MBP35 User Guide - Page 10

Registration - video baby monitor

Get Motorola MBP35 PDF manuals and user guides View all Motorola MBP35 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

2. Press p to switch ON the parent unit. The power LED will light up 3. in green. Press and hold p to switch OFF the parent unit. NOTE Once the baby and parent units are switched on, the display on the parent unit will show the video captured by the baby unit. When there is no connection or out of range, the icon on the LCD display will flash and the parent unit will beep continuously. Move the parent unit closer to the baby unit until the link is re-established. 2.5 Registration The baby monitor is already pre-registered upon your purchase. You do not need to register it again unless the baby unit loses its link with the parent unit. To re-register your baby monitor, follow the procedure below: 1. 2. tSPhwreeistm cshaonfhdf ebhlodotlhdfotm rhme ob,raeabntyhdaatnhned5npspaerrceeosnnstdup sniatsft.eornitthsewpitacrheenst unit, keeping on, until the power on LED flashes. The parent unit is then in registration mode. 3. Cover the camera lens on the baby unit with a black cloth or bag and then switch it on. 4. Wait for the 2 units to search and establish the link. 5. Remove the cover on the baby unit. The registration is complete when the display screen on the parent unit captures the video from the baby unit's camera. 10 Getting started

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
10
Getting started
2.
Press
p
to switch ON the parent unit. The power LED will light up
in green.
3.
Press and hold
p
to switch OFF the parent unit.
NOTE
Once the baby and parent units are switched on, the display on the parent
unit will show the video captured by the baby unit.
When there is no connection or out of range, the
icon on the LCD
display will flash and the parent unit will beep continuously. Move the
parent unit closer to the baby unit until the link is re-established.
2.5
Registration
The baby monitor is already pre-registered upon your purchase. You do
not need to register it again unless the baby unit loses its link with the
parent unit.
To re-register your baby monitor, follow the procedure below:
1.
Switch off both the baby and parent units.
2.
Press and hold
m
, and then press
p
on the parent unit, keeping
the
m
held for more than 5 seconds after it switches on, until the
power on LED flashes. The parent unit is then in registration mode.
3.
Cover the camera lens on the baby unit with a black cloth or bag and
then switch it on.
4.
Wait for the 2 units to search and establish the link.
5.
Remove the cover on the baby unit.
The registration is complete when the display screen on the parent unit
captures the video from the baby unit°s camera.