NEC DT100 User Manual - Page 49

Ofrecido por www.electromanuales.com Specifications Troubleshooting Model Number DT100 Optical LCD panel Size 1.3-in.(3 panels) Aspect ratio 4:3 Drive method Polysilicon TFT active matrix with micro lens array Number of pixels 786,432 pixels (1,024 dots x 768 dots) x3 Arrangement Stripe Lens Manual zoom X1-1.3, f=49mm -64 mm, F1.7-2.3 Lamp 200W New Super High pressure lamp Image size / Projection Distance Min. 30-in. (focal distance 1.43m/56.3") Max. 300-in. (focal distance 14.86m/585") Electrical Color reproduction Full color (16,770,000 colors) Scanning frequency Horizontal: 15 to 80kHz, Vertical: 50 to 75Hz Display of available resolution (RGB signal input) 1,024 x 768 dots (1,280 x 1,024 dots compressed display available) OHP Scanner 1/2-in. single plate CCD camera (2,000,000 pixels) Scan speed 4 frames/sec Scan size At 100%: 288mm x 216mm/11.3" x 8.5", At 200%: 144mm x 108mm/5.7" x 4.3" PC Signal system Separate signal system (Analog Video signals Analog: 0.7Vp-p/75Ω Video I/O RGB Input) Synchronizing Separate/composite: TTL level (posi/nega) signals Sync on green: 0.3Vp-p (nega) Input terminal 15-pin mini D-Sub Video Signal system NTSC, PAL or SECAM Input terminals RCA pin jack x 1, S-video terminal (mini DIN 4-pin) x 1 Monitor Video signal 0.7Vp-p/75Ω output Synchronizing signals Separate TTL level, negative polarity Output connector 15-pin mini D-Sub x 1 Audio input PC Audio signal 0.4Vrms/47KΩ Video Input terminal RCA pin jack (PC and video, 1 each) Monitor Audio signal 0.4Vrms/47KΩ 1 output Output terminal Stereo mini jack Audio output Built-in 2Wx2/8Ω speaker (stereo) Ambient temperature and humidity Temperature: 0 to 35°C/32° to 95°F, Humidity: 20 to 80% (no condensation allowed) Storage temperature and humidity Temperature: -10° to 50°C/14° to 122°F, Humidity: 20 to 80% Power requirement 100-120/220-240V AC 50/60Hz, 4A/2A Mechanical External dimensions 390mm (W) x 380mm (D) x 190mm (H)/15.35" (W) x 14.97" (D) x 7.48" (H) (not including protrusions) Weight Approx. 8.5kg/18.74 lbs Accessories Power cable, remote control, user's manual, batteries (SUM3/AA x 2) and RGB signal cable. Regulations UL Approved (UL 1950, CSA 950) Meets DOC Canada Class A requirements Meets FCC Class A requirements Meets AS/NZS3548 Class A Meets EMC Directive (EN55022, EN55024, EN61000-3-2, EN61000-3-3) Meets Low Voltage Directive (EN60950, TUV GS Approved) 1 The input signal from the selected device is output. • Specifications and design are subject to change without prior notice in the interest of product improvement. • We provide more information about our projectors through the World Wide Web at http://www.nec-pj.com/ • LCD panels are inherently susceptible to bad pixels. • The LCD panel may have pixel failures at the rate of 0.01% or less. E-49