NEC EA232WMi MultiSync EA232WMi-BK : user manual - Page 8

Quick Start To attach the MultiSync LCD monitor to your computer system, follow these instructions: 1. Turn off the power to your computer. 2. For PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws. For PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your system (Figure A.2). Tighten all screws. For MAC: Connect the Macintosh cable adapter to the computer, then attach the 15-pin mini D-SUB signal cable to the Macintosh cable adapter (Figure B.1). Tighten all screws. For PC with DisplayPort output: Connect the DisplayPort cable to the connector of the display card in your system (Figure B.2). DVI signal cable Figure A.1 Macintosh Figure A.2 Cable Adapter (not included) DisplayPort cable Figure B.1 (not included) Figure B.2 NOTE: Some Macintosh systems do not require a Macintosh cable adapter. 3. Place hands on each side of the monitor to tilt the LCD panel 30-degree angle and lift up to the highest position (Figure C.1). 4. Connect all cables to the appropriate connectors (Figure C.1). Connect the Headphone (not included) to the appropriate connector at the left side of the monitor (Figure C.1). When using the USB cable, connect the B type connector to the USB upstream port on the right back side of the monitor and the A type connector to the downstream port on the computer (Figure C.1a). If you can use the cord from the USB device, use one of the downstream ports on the side of the monitor. 30˚ Tilt A Type A Type B Type Highest Stand Position DisplayPort Headphone DVI D-Sub Audio Input USB B Type Figure C.1a Power Cord Figure C.1 NOTE: 1. Please use a DisplayPort cable with a DisplayPort logo. 2. The DisplayPort connector does not supply power to the connected component. 3. When removing the DisplayPort cable, hold down the top button to release the lock. English-6