NEC MM2000 MM2000B : MM2000B User Manual - Page 17
MM-DVI Interface Board Option
![]() |
View all NEC MM2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
MM-DVI Interface Board (Option) The DVI signal input board is available as an option. 1. Introduction (1) (2) (1) DVI-D Input Connector (DVI-D 24 Pin) Use a DVI-D Signal cable and connect it to the DVI output connector of a computer. (2) ACT Indicator Steady green light ....... Shows that this board is selected. NOTE • When Viewing a DVI Digital Signal: • Use the DVI-D signal cable compliant with DDWG (Digital Display Working Group) DVI (Digital Visual Interface) revision 1.0 standard. The DVI-D cable should be within 5 m (196") long. • To project a DVI digital signal, be sure to connect the PC and the Switcher using a DVI-D signal cable before turning on your PC or Switcher. • Turn on the Switcher first and select DVI (DIGITAL) from the source menu before turning on your PC. Failure to do so may not activate the digital output of the graphics card resulting in no picture being displayed. Should this happen, restart your PC. • Do not disconnect the DVI-D signal cable while the Switcher is running. If the signal cable has been disconnected and then re-connected, an image may not be correctly displayed. Should this happen, restart your PC. TIP For details about the compatible input signals, see page 23. 9
![](/manual_guide/products/nec-mm2000b-mm2000b-mm2000b-user-manual-e03bf9f/17.png)