NEC MM2000B MM2000B : MM2000B User Manual - Page 3
Address: Unit G, Stafford Park 12, Telford TF3 3BJ, U.K. - electronics
![]() |
View all NEC MM2000B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Important Information CAUTION • When switching off the Main Power switch, set the Switcher to the standby mode beforehand. Doing so can cause damage to the Switcher. • Do not try to touch the ventilation outlets as they can become heated while the switcher is turned on. • Do not eject a PC card or LAN card while its data is being accessed. Doing so can damage your PC card or LAN card. • Please do not handle the parts on the interface board with your bare hands. Doing so may cause damage due to electrostatic discharge. • Do not use the handle of the interface board to carry the Switcher. Doing so may cause injury or damage to the Switcher. Fire and Shock Precautions • Ensure that there is sufficient ventilation and that vents are unobstructed to prevent the build-up of heat inside your switcher. Allow at least 3 inches (10 cm) of space between your switcher and a wall. • Prevent foreign objects such as paper clips and bits of paper from falling into your switcher. Do not attempt to retrieve any objects that might fall into your switcher. Do not insert any metal objects such as a wire or screwdriver into your switcher. If something should fall into your switcher, disconnect it immediately and have the object removed by a qualified service personnel. • Do not place any liquids on top of your switcher. • When using a LAN cable: For safety, do not connect to the connector for peripheral device wiring that might have excessive Voltage. • Do not put the Switcher on its side when the power is turned on. For questions relating to unclear points or repairs Contact your dealer or the following support branches for questions relating to unclear points, malfunctions and repairs of the product. In Europe NEC Europe, Ltd. / European Technical Centre Address: Unit G, Stafford Park 12, Telford TF3 3BJ, U.K. Telephone: +44 1952 237000 Fax Line: +44 1952 237006 In North America NEC Corporation of America Digital Cinema Division Address: 4111 West Alameda Avenue Suite 412 Burbank, CA 91505 Telephone: 818 557 2500 *If the above line is busy, please dial as below; Telephone: 866 632 6431 Disposing of your used product EU-wide legislation as implemented in each Member State requires that used electrical and electronic products carrying the mark (left) must be disposed of separately from normal household waste. This includes projectors and their electrical accessories or lamps. When you dispose of such products, please follow the guidance of your local authority and/or ask the shop where you purchased the product. After collecting the used products, they are reused and recycled in a proper way. This effort will help us reduce the wastes as well as the negative impact to the human health and the environment at the minimum level. The mark on the electrical and electronic products only applies to the current European Union Member States. E-2
![](/manual_guide/products/nec-mm2000b-mm2000b-mm2000b-user-manual-e03bf9f/3.png)