NEC MT1035 User Manual - Page 13
RGB Input 2 Connector Mini D-Sub 15 pin, PC Control Port, Mouse Output Port, Remote Control Jack, - projector
View all NEC MT1035 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
5 RGB Input 2 Connector (Mini D-Sub 15 pin) Connect a Macintosh or compatible computer here using the signal cable and the monitor adapter that is supplied. Or connect your PC or RGB equipment such as IBM or compatible computers. Use the signal cable that is supplied to connect to a PC. RGB 2 Audio Input Mini Jack This is where you connect a second RGB audio output from a computer or another RGB source. 6 PC Control Port Use this port to connect your PC to control the MultiSync MT1035 Projector. This enables you to use your PC and serial communication protocol to control the projector. If you are writing your own program, command references are on pages 99 to 102. A cap is put on the port at the factory. Remove the cap when using the port. 7 Mouse Output Port Use this port to operate your computer's mouse functions from the NEC MultiSync MT1035 remote control. When your computer is connected here, the remote sensors on the LCD projector cabinet will receive your mouse commands. 8 Remote Control Jack Connect your remote control cable here for wired operation. 9 Built-in Security Slot ( ) This security slot supports the MicroSaver® Security System. MicroSaver® is a registered trademark of Kensington Microware Inc. The logo is trademarked and owned by Kensington Microware Inc. 23 6 78 S-VIDEO INPUT AUDIO L/MONO R RGB MONITOR OUTPUT AUDIO PC CONTROL MOUSE OUTPUT REMOTE CONTROL INPUT L/MONO R VIDEO INPUT AUDIO RGB INPUT 1 AUDIO RGB INPUT 2 AUDIO 5 AC IN 9 13 INTRODUCTION 24