NEC MT1035 User Manual - Page 45
Status Light Messages
View all NEC MT1035 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
5 TROUBLESHOOTING 87 This section helps you resolve problems you may encounter while setting up or using your MultiSync MT1035 LCD Projector. Status Light Messages Condition Status OFF Ⅵ Normal On continually Ⅵ The projector lamp has exceeded 2000 hours of operation and should be replaced. Blinking very rapidly (On and off in a cycle of 1 sec.) Ⅵ Either the lamp cover or filter cover is not fastened properly. Check each and reattach them if necessary. Blinking rapidly (On and off in a cycle of 4 sec.) Ⅵ The projector is overheated. • If there is insufficient ventilation around the projector or if the room where you're presenting is particularly warm, move the projector to a cooler location. • Check the filter and clean it if necessary. • If the problem persists, contact your NEC dealer for service. Blinking slowly (On and off in a cycle of 8 sec.) Ⅵ The cooling fan has stopped. Contact your NEC dealer for service. Blinking very slowly (On and off in a cycle of 12 sec.) Ⅵ The lamp is not turned on. • The projector was turned off and back on too quickly. Turn off the projector, wait one minute, then turn the projector back on. Or the lamp is burnt out. 45 TROUBLE SHOOTING 88