NEC PX-50XM1A 50MP1 - Page 14

Using the wired remote control mode Connect the supplied remote cable to the remote control unit's remote jack and the "REMOTE CONTROL" terminal on the monitor. When the cable is connected, the mode automatically switches to wired remote control. When the wired remote control mode is used, the remote control unit can be operated even if no batteries are loaded. Operating Range * Use the remote control unit within a distance of about 7 m/ 23ft. from the front of the monitor's remote control sensor and at a horizontal angle of within 30°. * The remote control operation may not function if the monitor's remote control sensor is exposed to direct sunlight or strong artificial light, or if there is an obstacle between the sensor and the remote control unit. RS MUST ORE THAN RATING NCE 6 OHM LEFT AUDIO 3 RGB2/ DVD2/ HD2 AUDIO 2 DVD1/HD1 AUDIO 1 VIDEO 1 VIDEO 2 VIDEO 3 L(MONO) R Y CB/PB CR/PR L(MONO) R RGB 1 R/CR/PR G/Y B/CB/PB HD VD L(MONO) R RGB 3 (Digital RGB) CONTROL LOCK ON /OFF REMOTE CONTROL EXTERNAL CONTROL CONTROL LOCK ON /OFF REMOTE CONTROL EXTERNAL CONTROL Remote Control Cable To Remote Jack LUME UP LEFT/- RIGHT/+ INPUT SELECT /EXIT POWER/STANDBY Approx. 7m/ 23ft 30˚ 30˚ Handling the remote control unit • Do not drop or mishandle the remote control unit. • Do not get the remote control unit wet. If the remote control unit gets wet, wipe it dry immediately. • Avoid heat and humidity. • When not using the remote control unit for a long period, remove the batteries. • Do not use new and old batteries together, or use different types together. • Do not take apart the batteries, heat them, or throw them into a fire. • When using the remote control unit in the wireless condition, be sure to unplug the remote cable from the REMOTE CONTROL terminal on the monitor. 7