NEC PX-50XM3A 42VP4/42XM2/50XM3/61XM2 - Page 10

L (MONO) L (MONO) L (MONO) VIDEO 3 REMOTE External Control OUT IN DV I ( Digital RGB ) RGB 1 (IN / OUT) Cb/Pb Cr/Pr VD Cb/Pb HD Y Cr/Pr R Y VIDEO 1 ( I N / OUT) AUDIO 3 R B/ G/ R/ R RGB 3 RGB2 / DVD2 / HD2 AUDIO 2 DVD1 / HD1 AUDIO 1 VIDEO VIDEO 2 Rear View/ Terminal Board C D E F G H I J K AB A AC IN Connect the included power cord here. B EXT SPEAKER L and R Connect speakers (optional) here. Maintain the correct polarity. Connect the (positive) speaker wire to the EXT SPEAKER terminal and the (negative) speaker wire to the EXT SPEAKER terminal on both LEFT and RIGHT channels. Please refer to your speaker's owner's manual. C VIDEO1, 2, 3 (BNC, RCA, S-Video) Connect VCR's, DVD's or Video Cameras, etc. here. VIDEO1 can be used for Input or Output (see page 10). D AUDIO1, AUDIO2, AUDIO3 These are audio input terminals. The input is selectable. Set which video image to allot them from the audio menu screen. E DVD1 / HD1 Connect DVD's, High Definition or Laser Discs, etc. here. G RGB1 (mini D-Sub 15pin) Connect an analog RGB signal from a computer, etc. here. This input can be used for Input or Output. (see page 10) H RGB3 (DVI 24pin) Connect a digital signal (TMDS) from a source with a DVI output. (see page 8) I EXTERNAL CONTROL This terminal is used when operating and controlling the monitor externally (by external control). J REMOTE IN Connect the remote cable* to the remote control's remote jack to obtain wired remote control. K REMOTE OUT Connect the remote cable* to the REMOTE IN jack of the other display monitor to obtain wired remote control. * The 1/8 Stereo Mini cable must be purchased separately. F RGB2/ DVD2/ HD2 RGB2: You can connect an analog RGB signal and the syncronization signal. DVD2/ HD2: You can connect DVDs, High Definition sources, Laser Discs, etc. here. This input can be set for use with an RGB or component source. (see page 24) 3