NaceCare TGB2228 COMING SOON Owners Instructions - Page 15
Trouble Shooting, Specifications
View all NaceCare TGB2228 COMING SOON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Specifications Model - TGB 8572 Brush Weight Brush Sizes Brush Pressure Pad sizes Pad Pressure Cleaning Area 13/28/50kg Brush Motor 2 x 370 mm Brush Speed 8.2/17.5/31.3 g/cm2 2 x 360 mm Vac Motor Vac Motor Suction @ Squeegee 600W 150rpm 400W 120 mbar Water Flow Transaxle Power Gradient Drive Speed Gross Weight 0 - 3l/min 400W Max 6% 0 - 4.2 kph 355kg 6.9/14.8/26.4 g/cm2 1250m2/HOUR@2kph Vac Motor Airflow @ Squeegee Water Capacity 24 l/sec 85L Nett Weight Power Source 270kg Gel Battery 24V (4 x 12V) 200Ah Run Time 5hr MAX Recharge Time Battery Weight Dimensions Squeegee Width 8-10HRS 20A Charger 12v/100Ah - 31.8kg Width = 762 mm Length = 1513 mm Height = 1144 mm 948mm Noise ≤70dB(A)± 3dB(A) Hand Arm Vibration Water Ingress Protection ≤2.5m/s2 IPX4 PROBLEM Machine will not operate Vacuum will not operate Poor water pick-up No brush / scrub function Little or no water flow Machine just 'stops' during operating CAUSE Missing or blown fuses Low battery charge Machine is connected and charging Waste tank full switch stuck or clogged Key is off or missing Handle safety fuse blown Missing or blown fuse Waste tank full switch stuck or clogged Vacuum switch not engaged Waste water tank full Waste water tank full Clogged / blocked vacuum hose Loose hose connections Debris basket filter clogged / blocked Separator filter clogged / blocked Poor separator seal Damaged separator seal Damaged / split vacuum hose Damaged floor tool blades Low battery charge Floor tool incorrectly adjusted No brushes fitted Brush deck raised Missing or blown fuses Clean water tank empty Clean water tank filter blocked / clogged Water flow not on Brush deck raised Too much load on the brush system Brush motor fuse blown due to high load Handle safety fuse blown Trouble Shooting SOLUTION Fit or replace fuse (page 5) Charge batteries (page 13 / 14) Take off charge (page 13) Inspect & clean switch inside tank (page 11) Insert key & turn to operating position Replace fuse (or contact service engineer) Fit or replace fuse (page 5) Inspect & clean switch inside tank (page 11) Press switch Empty waste water tank (page 11) Empty waste water tank (page 11) Remove and clean (page 11) Push tight connections (page 7) Remove and clean (page 11) Remove and clean (Page 11) Clean and refit (page 11) Renew (contact service dept) Renew (contact service dept) Renew (contact service dept) Re-charge batteries (page 13 / 14) Adjust floor tool Check and fit (page 6) Lower brush deck (page 9) Fit or replace fuse (page 5) Fill clean water tank (page 7) Remove and clean (11) Switch on water flow (Page 9) Lower brush deck (page 9) Decrease the brush load to best suit the floor type (page 10). Replace fuse & reduce load (page 5) Replace fuse (or contact service engineer) Failure to rectify the problem or in the event of a breakdown contact your Numatic dealer or Numatic Technical helpline +44 (0)1460 269268 T 01460 68600 15