NaceCare TGB2228 COMING SOON Owners Instructions - Page 7

Machine Set-up Guide Fitting the Hose Guide The vacuum hose has a U-bend clip which creates a U-bend in the hose preventing water spillage when the vacuum is switched off. If you need to remove the U-bend clip for any reason always ensure it is refitted correctly before you resume operation. 250mm - 300mm NOTE: DO NOT push the vacuum hose onto the floor tool with the floor tool in the raised position. Filling the Clean Water Tank The TGB 8572 is equipped with a large capacity clean water tank allowing for large areas to be covered in a single fill. 10 1 Refit vacuum hose to the Floor tool when finished. 2 To fill the clean water tank, extend the hose located to the rear of the machine in the centre of the removable filler cap (1). Pull out hose. Open the stopper and place hose under water tap, or use a hose to commence filling. The tank can also be filled by unscrewing the filler cap and using a bucket or similar container (2). NOTE: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the clean water tank during the filling process. If using a bucket or similar, ensure it is always clean and free from debris. T 01460 68600 7