Netgear 771S AT Command Reference - Page 8
Result codes, References, Terminology and acronyms, Current firmware versions, Document structure
View all Netgear 771S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
AirCard 77Xs / 34xU AT Command Reference Result codes Result codes are not shown in the command tables unless special conditions apply. Generally the result code OK is returned when the command has been executed. ERROR may be returned if parameters are out of range, and is returned if the command is not recognized or is not permitted in the current state or condition of the modem. References This guide covers the command sets used by OEMs, designers and testers of NETGEAR AirCard devices, plus general operational use commands. You may also want to consult the other documents available on our website at www.netgear.com. Terminology and acronyms This document makes wide use of acronyms that are in common use in data communications and cellular technology. Current firmware versions Version To determine your firmware revision, enter the identification command AT+GMR. Upgrading If your modem firmware is an earlier version, you can acquire updated firmware by visiting support.netgear.com and searching by your product model number. Document structure This document describes the proprietary commands listed in the tables below- each table corresponds to a specific chapter. AT Password Commands-Commands used to enable access to passwordprotected AT commands and to set the AT command password. Table 1-1: AT password commands Command Description !ENTERCND Enable access to password-protected commands !SETCND Set AT command password Page 14 14 8 Proprietary and Confidential 4114487