Netgear FA410 FA410 Installation Guide - Page 5
Connect the Network Cables
View all Netgear FA410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Connect the Network Cables Using the UTP cable that is supplied, connect any port on the hub to the port on the network card. Note: One of the ports on NETGEAR hubs is switchable between Normal (MDI-X) and Uplink (MDI) with a Normal/Uplink push button. If you are using this switchable port on a NETGEAR hub to connect to a PC or the network card, make sure the Normal/Uplink push button is set to Normal. PC with network card installed Power adapter Notebook PC RJ-45 connectors Hub Category 5 10/100 Mbps UTP cables* *Use the cable provided or any Category 5 UTP cable. Maximum length = 100 meters (300 feet) Model FA410TX Network Card with RJ-45 adapter cable Model FA410TX Network Card Installation Giude
Model FA410TX Network Card Installation Giude
Using the UTP cable that is supplied, connect any port on the hub to the port on the network card.
Note:
One of the ports on NETGEAR hubs is switchable between Normal (MDI-X)
and Uplink (MDI) with a Normal/Uplink push button. If you are using this switchable
port on a NETGEAR hub to connect to a PC or the network card, make sure the
Normal/Uplink push button is set to Normal.
Connect the Network Cables
RJ-45
connectors
PC with network
card installed
Power adapter
Notebook PC
*Use the cable provided or any Category 5 UTP cable.
Maximum length = 100 meters (300 feet)
Category 5 10/100 Mbps UTP cables*
Model FA410TX
Network Card with
RJ-45 adapter cable
Hub