Netgear FA510 FA510 Installation Guide - Page 5

Install the Network Driver This guide provides you with instructions for installing the Windows Network Driver. The steps given in these instructions are for users of Windows 98. If you are using Windows 95, read these instructions thoroughly for an overview of the steps that are necessary for the installation of the software driver. If you are installing network cards and drivers on more than one computer operating with Windows 95, you might find that all versions of Windows 95 do not respond with the same screens, and windows might open in a different order. Note: You must install the network card (instructions on other side of this guide) before installing the network driver. Before you proceed with the installation steps, decide on a name for your network and for each PC (each name must be only one word). You also need to have the Windows CD-ROM and the FA510 Drivers and Diagnostics Disk ready to use in the installation process. Note: If the "Insert Disk" window opens and the "Please insert the disk labeled Windows 98..." message appears at any time during the following process, insert the Windows 98 CD-ROM in Drive D (the CD-ROM drive) and click on "OK." Then follow the next step in the instructions. 1. Turn on the power to the computer and start Windows 98. The new hardware is found. 2. Add New Hardware Wizard This wizard searches for new drivers for: PCI Ethernet Controller A device driver is a software program that makes a hardware device work. Click on "Next." < Back Next> Cancel Model FA510 Network Card Installation Guide