Netgear FSM726 FSM726v2 Setup Manual - Page 61
Status > MAC Address Table, duplex 10M Full; 100 Mbps half duplex 100M Half; or 100 Mbps full
UPC - 606449026856
View all Netgear FSM726 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
700 Series Software Manual v2.1 • Link: A green triangle pointing up indicates a valid link, while a red triangle pointing down indicates no link. • On/Off: Indicates if the port is enabled or disabled by the Administrator. • State: This refers to the Spanning Tree state of the port. Ports will be Blocking (Blk), Listening (Lis), Learning (Lrn), Forwarding (Fwd) or Disabled (Dis). • Speed: Indicates the speed and duplex for the port. The possible entries are Auto-negotiation (Auto); 10 Mbps half duplex (10M Half); 10 Mbps full duplex (10M Full); 100 Mbps half duplex (100M Half); or 100 Mbps full duplex (100M Full). • Flow Control: Indicates whether Flow Control support is set for automatic (Auto) or off (Disabled) • Priority Indicates if the port is set to high priority or normalpriority. This is an advanced feature that is configured under Traffic Prioritization • Trunk ID Indicates if the port is a member of a trunk by showing the ID number of the trunk. This is an advanced feature that is configured under Port Trunking Status > MAC Address Table Figure 5-10: MAC Address Table The MAC Address Table is a dynamic address lookup table that allows you to view the dynamic MAC addresses that are currently in the address database. When a MAC address is in the database, the packets intended for that address are forwarded directly to that port. You can filter the displayed addresses by port, VLAN, and/or MAC address by checking those fields. Web-Based Management Interface 5-11