Netgear FSM726 FSM726v2 Setup Manual - Page 63
Set-up> IP Configuration, Enter System Name, System Contact, or System Location. - fsm726s reset
UPC - 606449026856
View all Netgear FSM726 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
700 Series Software Manual v2.1 This page will allow access to the system information parameters. To do so: 1. Enter System Name, System Contact, or System Location. 2. Click Apply to change the System Configuration and save it in NVRAM. 3. Reset the system to implement the changes (> Save Configuration). Set-up> IP Configuration Figure 5-13: IP Configuration This menu manages the IP related information of the system. IP Assignment Mode • Manual - You manually enter IP-related information • BootP - Bootstrap Protocol, which allows the FSM726 switch to discover its own IP address from a BootP server on the network • DHCP - The switch accepts DHCP broadcast from a DHCP server and automatically configures IP related information Note: In DHCP mode, if the switch fails to get a DHCP assignment, the switch defaults to 192.168.0.1 as its IP address. To enable quick and easy set-up, the default setting is DHCP. However, DHCP addresses change over time, and you need to know the IP address of your switch so that you can remotely manage it. After completing the initial setup, change the IP assignment mode from DHCP to manual. If you choose Manual mode, enter site-specific IP address, Gateway address and Net mask. Web-Based Management Interface 5-13