Netgear FVG318v1 FVG318 Reference Manual - Page 22
The FVG318 Rear Panel, Table 1-1., LED Descriptions,
View all Netgear FVG318v1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
ProSafe 802.11g Wireless VPN Firewall FVG318 Reference Manual You can use some of the LEDs to verify connections. Viewed from left to right, Table 1-1 describes the LEDs on the front panel of the firewall. These LEDs are green when lit. Table 1-1. LED Descriptions LED Label PWR TEST INTERNET 100 (100 Mbps) LINK/ACT (Link/Activity) LOCAL 100 (100 Mbps) LINK/ACT (Link/Activity) WLAN Activity On On Off On Off On Blinking On Off On Blinking On Off Description Power is supplied to the firewall. The system is initializing. The system is ready and running. The Internet (WAN) port is operating at 100 Mbps. The Internet (WAN) port is operating at 10 Mbps. The Internet port has detected a link with an attached device. Data is being transmitted or received by the Internet port. The Local port is operating at 100 Mbps. The Local port is operating at 10 Mbps. The Local port has detected a link with an attached device. Data is being transmitted or received by the Local port. The wireless interface is on. The wireless interface is off. The FVG318 Rear Panel The rear panel of the VPN firewall contains the port connections listed below. Antenna Figure 1-2 FACTORY Reset Button LOCAL Ports INTERNET Power Port 1-6 Introduction v1.0, September 2007