Netgear GSM7248R Layer 3 Switches - Routing VLANs with shared access to the In - Page 14
Configuring the switch default route - static routing
View all Netgear GSM7248R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
8 - Configuring the switch default route Although RIP is enabled by default, this is not necessary for routing to take place and can be disabled. When creating a routing VLAN a static route is added to the Layer 3 switch routing table A summary of the routes can be found in Routing - Routing table - Route configuration. In the same page it is possible to set the DefaultRoute. This is necessary to instruct the Layer 3 switch that any traffic not destined to the local VLANs should be sent to a Default Gateway. In our scenario the Internet Default Gateway is the DGFV338 on IP address 192.168.2.254. The DefaultRoute is configured accordingly in the next picture. 14
14
8
–
Configuring the switch default route
Although RIP is enabled by default, this is not necessary for routing to take place and can be
disabled.
When creating a routing VLAN a static route is added to the Layer 3 switch routing table
A summary of the routes can be found in Routing
–
Routing table
–
Route configuration.
In the same page it is possible to set the DefaultRoute.
This is necessary to instruct the Layer 3 switch that any traffic not destined to the local VLANs
should be sent to a Default Gateway.
In our scenario the Internet Default Gateway is the DGFV338 on IP address 192.168.2.254. The
DefaultRoute is configured accordingly in the next picture.