Netgear KWGR614-100NAS KWGR614 Reference Manual - Page 26
Default Factory Settings, Manual method, If WPA-PSK or WPA2-PSK Authentication is Used, Passphrase
![]() |
UPC - 606449049893
View all Netgear KWGR614-100NAS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
54Mbps Wireless Router Model KWGR614 Reference Manual • Manual method. These values are not case sensitive. For 64-bit WEP, enter 10 hex digits (any combination of 0-9 or a-f). For 128-bit WEP, enter 26 hex digits. Key 1 Key 2 Key 3 Key 4 If WPA-PSK or WPA2-PSK Authentication is Used: - Passphrase These characters are case sensitive. Enter a word or group of printable characters. When you use WPA-PSK, the other devices in the network will not connect unless they are set to WPA-PSK as well and are configured with the correct Passphrase. Similarly, when you use WPA2-PSK, the other devices in the network will not connect unless they are set to WPA2-PSK and are configured with the correct Passphrase. Use the procedures described in the following sections to configure the KWGR614. Store this information in a safe place. Default Factory Settings When you first receive your KWGR614, the default factory settings are in effect as shown below. You can restore these defaults with the Factory Default Restore button on the rear panel. After you install the 54Mpbs Wireless Router, use the procedures below to customize any of the settings to better meet your networking needs. FEATURE Wireless Router Radio Wireless Access List (MAC Filtering) SSID broadcast SSID 802.11b/g RF Channel Mode Authentication Type WEP DHCP Server DHCP range DEFAULT FACTORY SETTINGS Enabled All wireless stations allowed Enabled NETGEAR 6 802.11b/g/g and b Automatic Disabled Enabled 192.168.1.2 to 192.168.1.254 2-8 Wireless Configuration v1.2, September 2006
![](/manual_guide/products/netgear-kwgr614-kwgr614-reference-manual-d894027/26.png)