Netgear M5300-28G3 Software Administration Manual - Page 358
Create a Mixed Stack with an M5300-28G3 Switch and a GSM7328Sv2 Switch, CAUTION
View all Netgear M5300-28G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 358 highlights
ProSafe Managed Switch CAUTION: Since the existing configuration might be invalid with the new SDM template, changing the SDM template on the switch causes the switch configuration be set to the factory defaults. A warning message is displayed in the browser window if the web GUI is used or on the console if the CLI is used. You are prompted to confirm that the current configuration will be cleared and the switch will be rebooted. Create a Mixed Stack with an M5300-28G3 Switch and a GSM7328Sv2 Switch The following example demonstrates how to stack an M5300-28G3 switch and a GSM7328Sv2 switch. Stacking other combinations of M5300 series switches and GSM73xxS switches use the same process. Before an M5300 switch can be stacked with a GSM73xxSv2 switch, both switches must have the same 10.0 firmware version. The SDM templates are only available in release 10.0. If for example, the GSM7328Sv2 switch is running firmware version 8.0.3.25, the GSM7328Sv2 switch must first be upgraded to one of the version 10.0 images available from the NETGEAR product support website. The 10.0 version for the GSM7328Sv2 switch must be the same version that is used in the M5300 switch. After the GSM7328Sv2 switch is upgraded to firmware version 10.0.0.23 (assuming this is the available version on GSM7328Sv2 website and version 10.0.0.23 is running on the M5300-28G3), use the show sdm prefer command to show the default SDM template setting: (GSM7328Sv2) #show sdm prefer The current template is the 'dual ipv4 and ipv6 smb' template. ARP Entries 1024 IPv4 Unicast Routes 224 IPv6 NDP Entries 512 IPv6 Unicast Routes 128 ECMP Next Hops 4 IPv4 Multicast Routes 128 IPv6 Multicast Routes 128 By default, an M5300 switch using version 10.0 firmware has the SDM template set to 'dual ipv4 and ipv6 enterprise'. The GSM7328Sv2 switch using version 10.0.0.23 firmware has the SDM template set to 'dual ipv4 and ipv6 smb'. You need to change the SDM template on the M5300 switch to match the template on the GSM7328Sv2 switch. 358 | Chapter 19. Switch Stacks