Netgear M5300-28G3 Software Administration Manual - Page 72

ProSafe Managed Switch Set Up VLAN Routing for the VLANs and the Switch The example is shown as CLI commands and as a Web interface procedure. CLI: Set Up VLAN Routing for the VLANs and the Switch 1. The following code sequence shows how to enable routing for the VLANs: (Netgear Switch) #vlan data (Netgear Switch) (Vlan)#vlan routing 10 (Netgear Switch) (Vlan)#vlan routing 20 (Netgear Switch) (Vlan)#exit This returns the logical interface IDs that will be used instead of the slot/port in subsequent routing commands. Assume that VLAN 10 is assigned the ID 3/1, and VLAN 20 is assigned the ID 3/2. 2. Enable routing for the switch. (Netgear Switch) #config (Netgear Switch) (Config)#ip routing (Netgear Switch) (Config)#exit 3. The next sequence shows an example of configuring the IP addresses and subnet masks for the virtual router ports. (Netgear Switch) (Config)#interface vlan 10 (Netgear Switch) (Interface-vlan 10)#ip address 192.150.3.1 255.255.255.0 (Netgear Switch) (Interface-vlan 10)#exit (Netgear Switch) (Config)#interface vlan 20 (Netgear Switch) (Interface-vlan 20)#ip address 192.150.4.1 255.255.255.0 (Netgear Switch) (Interface-vlan 20)#exit (Netgear Switch) (Config)#exit 72 | Chapter 5. VLAN Routing