Netgear MA111v1 MA111v1 User Manual - Page 13

Troubleshooting Problem Cause Solution No lights are lit on the Wireless USB Adapter. The Wireless USB Adapter • Remove and reinsert the Wireless is not inserted properly into USB Adapter. the USB port on your PC. Or the proper MA111 Wireless USB Adapter driver is not loaded. • Check the device manager in Windows to see if the adapter card is properly recognized in the Windows operating system. Reload the driver if necessary. • Try to install the Wireless USB Adapter in different USB port if it's available. The LED is blinking repeatedly. The Wireless USB Adapter • The Access Point may not be powered on. is not associated to any • The Access Point and the MA111 Wireless Access Point properly. You USB Adapter are not configured with the may not have configured same wireless parameters. Check the SSID, the wireless parameters of and WEP encryption settings. the wireless nodes to be the same as the Access Point. • The Access Point may be out of range. Try moving the system closer to the Access Point or readjusting the antenna on the Access Point. You may also move the Access Point to a higher location for better signal reception by the Wireless USB Adapter. I am associated This could be a physical and connected layer problem or a network to an Access configuration problem. Point, but I cannot see the other computers on the Ethernet side of the network. • Check to make sure that the Access Point is physically connected to the Ethernet network. • Make sure that the IP addresses and the Windows networking parameters are all configured correctly. 23 CE Declaration of Conformity For the following equipment: Wireless USB Adapter MA111 0682 ! is herewith confirmed to comply with the requirements set out in the Council Directive on the Approximation of the Laws of the Member States relating to Electromagnetic Compatibility and Radio Spectrum Matters (99/5/EC), Low-voltage Directive (73/23/EEC) and the Amendment Directive (93/68/EEC). For the evaluation regarding the Directives, the following standards were applied: • EN 60950: 2000 • EN 301 489-17 V1.1.1:09-2000 • EN 301 489-1 V1.3.1:09-2001 • EN 300 328-1 V1.3.1: 12-2001 • EN 300 328-2 V1.2.1: 12-2001 Déclaration de conformité CE Il est certifié que l'équipement suivant : Wireless USB Adapter MA111 0682 ! est conforme aux exigences définies par la Directive du Conseil concernant le rapprochement des législations des États Membres relatives à la compatibilité électromagnétique (99/5/EC), la Directive sur les basses tensions (73/23/CEE) et la Directive d'amendement (93/68/CEE). Les normes suivantes ont été appliquées pour évaluer la conformité à ces Directives : • EN 60950: 2000 • EN 301 489-17 V1.1.1:09-2000 • EN 301 489-1 V1.3.1:09-2001 • EN 300 328-1 V1.3.1: 12-2001 • EN 300 328-2 V1.2.1: 12-2001