Netgear WAG302 WAG302v2 Reference Manual - Page 31
Access Point Name., Country/Region., DHCP Client, IP Address., IP Subnet Mask., Default Gateway.
View all Netgear WAG302 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual • Access Point Name. This unique name is the access point NetBIOS name. The default Access Point Name is on the bottom label of the WAG302v2. The default name is netgearxxxxxx, where xxxxxx represents the last six hexadecimal digits of the WAG302v2 MAC address. You can change the name to a unique name up to 15 characters long. • Country/Region. This is the region where the WAG302v2 can be used. It may not be legal to operate the wireless features of the wireless access point in a region other than one of those identified in this field. For products sold in the United States, the default country domain is preset. For products sold outside of the United States, you must select a country or region. • DHCP Client: By default, the Dynamic Host Configuration Protocol (DHCP) client is disabled. If you have a DHCP server on your LAN and you enable DHCP, the wireless access point get its IP address, subnet mask and default gateway settings automatically from the DHCP server on your network when you connect the WAG302v2 to your LAN. Note: To connect to the WAG302v2 after the DHCP server on your network assigns it a new IP address, enter the access point name into the address field of your Web browser. The default access point name is netgearxxxxxx, where xxxxxx represents the last 6 bytes of the MAC address. The default name is printed on the bottom label of the WAG302v2. • IP Address. The default IP address is 192.168.0.230. To change it, enter an unused IP address from the address range used on your LAN (factory default: 192.168.0.230); or enable DHCP. • IP Subnet Mask. Enter the subnet mask value used on your LAN (factory default: 255.255.255.0). • Default Gateway. Enter the IP address of the gateway for your LAN. For more complex networks, enter the address of the router for the network segment to which the wireless access point is connected (factory default: 0.0.0.0). • DNS Server. Enter the IP address of the Domain Name Server (DNS) you want to use (factory default: 0.0.0.0). • Spanning Tree Protocol. Enable or disable spanning tree protocol (factory default: enabled). Spanning tree protocol provides network traffic optimization in settings with multiple WAG302v2 Wireless Access Points. Basic Installation and Configuration 2-9 v1.0, May 2006