Netgear WG302 WG302v1 Reference Manual - Page 31
Step 3: Deploy the ProSafe 802.11g - access point setup
UPC - 606449030365
View all Netgear WG302 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
NETGEAR ProSafe 802.11g Wireless Access Point WG302 Reference Manual Rest of World United States Figure 2-4. 7. Configure the wireless interface for wireless access. See the online help or "Configuring Wireless Settings" on page 2-11 of this Reference Manual for full instructions. Note: You must set the Regulatory Domain. It may not be legal to operate the wireless access point in a region other than one of those identified in this field. Now that you have finished the setup steps, you are ready to deploy the WG302 in your network. If needed, you can now reconfigure the computer you used in step 1 back to its original TCP/IP settings. Step 3: Deploy the ProSafe 802.11g 1. Disconnect the WG302 and position it where you will deploy it. The best location is elevated, such as wall mounted or on the top of a cubicle, at the center of your wireless coverage area, and within line of sight of all the mobile devices. 2. Lift the antenna on either side so that they are vertical. Note: Consult the antenna positioning and wireless mode configuration information in "Advanced Configuration" on page 4-1 of the Reference Manual. 3. Connect an Ethernet cable from your ProSafe 802.11g to a LAN port on your router, switch, or hub. Basic Installation and Configuration 2-7 v4.0, April 2006