Netgear WG302 WG302v1 Reference Manual - Page 78
Configuring a Point-to-Point Bridge, Under Advanced on the maim menu - network address
UPC - 606449030365
View all Netgear WG302 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
NETGEAR ProSafe 802.11g Wireless Access Point WG302 Reference Manual Figure 4-4. Configuring a Point-to-Point Bridge To configure a point-to-point bridge as shown in Figure 4-5: 1. Under Advanced on the maim menu, select Advanced Access Point Settings. The Advanced Access Point Settings screen will display. 2. Configure the WG302 (AP1) on LAN Segment 1 in Point-to-Point Bridge mode. 3. Configure the WG302 (AP2) on LAN Segment 2 in Point-to-Point Bridge mode. AP1 must have AP2's MAC address in its Remote MAC Address field and AP2 must have AP1's MAC address in its Remote MAC Address field. 4. Configure and verify the following parameters for both access points: • Verify that the LAN network configuration of the ProSafe 802.11gs both are configured to operate in the same LAN network address range as the LAN devices 4-6 Advanced Configuration v4.0, April 2006