Nikon 120ED Repair Manual - Page 6

FCA45001 - R.3498.A 5 ) Setting of ISO values for commands 3, 4 and 5 ©Turn off MOS as turning on SBS. While "command 3", "command 4" or "command 5" is displayed, operate MOS. Each time MOS is operated, the value is increased one by one. (The ISO value which was read from the DX code is displayed as the initial value. When the value is increased to "ISO3200", it returns to "ISO50".) When the desirable data is selected, turn off SBS and MOS. Data setting is completed. 6 ) Execution of test ©After the desirable command is set in Procedure 2), operate the camera normally. ©The camera operates according to the set command. The test can be executed repeatedly. 7 ) Display of zoom edge number ©In "command 1-5", operate ZSW to drive the lens barrel. After ZSW is turned off, the edge number between the encoder position and stop position is displayed for 1 second. (It is not displayed while the zoom is driving.) 8 ) Display of panorama ©In "command 1-5", turn on ZDS at W end. The PAR set status is displayed. 9 ) Setting of another command ©If another command must be executed subsequently under the manual test mode, return to Procedure 1) and set the manual test mode again. In this case, the timer should be set to "3 seconds" for setting. ©When a command is newly set, the previous command is reset. (Two commands cannot be executed at the same time.) 1 0 ) Cancel of test mode ©Turn off MSW, and the test mode is canceled. ©Select "command 0" and exit from the test mode. The test mode is canceled. ©Even if the lens barrel is driven at W end with the timer at "2 minutes", the manual test mode is not canceled. ®If the camera back is opened while the bulb is opened, the bulb keeps open. ©Even if the test mode is canceled, the set ISO value keeps valid. - M 4 - Zoom 120 ED -