Nikon Coolpix S4 User Manual - Page 93

Cleaning, Monitor

Get Nikon Coolpix S4 - Coolpix S4 - Digital Camera PDF manuals and user guides
UPC - 410000220139
View all Nikon Coolpix S4 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 93 highlights

Cleaning Lens: Avoid touching glass parts with your fingers. Remove dust or lint with a blower (typically a small device with a rubber bulb attached to one end that is pumped to produce a stream of air out the other). To remove fingerprints or other stains that can not be removed with a blower, wipe the lens with a soft cloth, using a spiral motion that starts in the center of the lens and works out to the edges. If this fails to clean the lens, wipe with a dry cloth lightly dampened with commercial lens cleaner. Monitor: Use a blower to remove dust or lint from the protective acrylic covering. To remove fingerprints and other stains, clean the monitor with a soft, dry cloth, being careful not to apply pressure. Avoid contact with liquid crystal Should the monitor break, care should be taken to avoid injury due to broken glass and to prevent the liquid crystal from the display touching the skin or entering the eyes or mouth. Body: Use a blower to remove dust, dirt, or sand then wipe gently with a soft, dry cloth. After using the camera at the beach or seaside, wipe off any sand or salt with a dry cloth lightly dampened with fresh water, then dry thoroughly. The camera may be damaged if foreign matter gets inside the camera body. Nikon cannot accept liability for damage caused by dirt or sand. Do not use alcohol, thinner, or other volatile chemicals. Notes on the Monitor • The monitor may contain a few pixels that are always lit or that do not light. This is a characteristic common to all TFT LCD displays, and does not indicate a malfunction. Images recorded using the product will not be affected. • When you frame bright subjects, vertical comet-like streaks that whiten toward either end may appear in the display. This phenomenon, known as "smear," does not appear in the final photograph and does not indicate a malfunction. Some smear may appear in movies. • Images in the monitor may be difficult to see in a bright light. • The monitor is lit by an LED backlight. Should the monitor begin to dim or flicker, contact your Nikon service representative. 83 Technical Notes

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
83
Technical Notes
Cleaning
Lens
: Avoid touching glass parts with your fingers.
Remove dust or lint with
a
blower
(typically a small device with a rubber bulb attached to one end that
is pumped to produce a stream of air out the other).
To remove fingerprints
or other stains that can not be removed with a blower, wipe the lens with a
soft cloth, using a spiral motion that starts in the center of the lens and works
out to the edges.
If this fails to clean the lens, wipe with a dry cloth lightly
dampened with commercial lens cleaner.
Monitor
: Use a blower to remove dust or lint from the protective acrylic cover-
ing.
To remove fingerprints and other stains, clean the monitor with a soft,
dry cloth, being careful not to apply pressure.
Avoid contact with liquid crystal
Should the monitor break, care should be taken to avoid injury due to broken
glass and to prevent the liquid crystal from the display touching the skin or
entering the eyes or mouth.
Body
: Use a blower to remove dust, dirt, or sand then wipe gently with a soft,
dry cloth. After using the camera at the beach or seaside, wipe off any sand or
salt with a dry cloth lightly dampened with fresh water, then dry thoroughly.
The camera may be damaged if foreign matter gets inside the camera body.
Nikon cannot accept liability for damage caused by dirt or sand.
Do not use alcohol, thinner, or other volatile chemicals.
Notes on the Monitor
• The monitor may contain a few pixels that are always lit or that do not light.
This is
a characteristic common to all TFT LCD displays, and does not indicate a malfunction.
Images recorded using the product will not be affected.
• When you frame bright subjects, vertical comet-like streaks that whiten toward either
end may appear in the display.
This phenomenon, known as “smear,” does not ap-
pear in the final photograph and does not indicate a malfunction.
Some smear may
appear in movies.
• Images in the monitor may be difficult to see in a bright light.
• The monitor is lit by an LED backlight.
Should the monitor begin to dim or flicker,
contact your Nikon service representative.