Nikon NF80B User Manual - Page 52

Troubleshooting-continued LCD panel End blinks - HI appears Lo appears - buLb blinks Viewfinder Cause Remedy Page End blinks • The end of the film roll • Rewind film by pressing 29, 36 has been reached the two film rewind (When ·1 is buttons „. selected). / blinks • Autofocus is not • Focus manually. 47 possible. HI appears • Overexposure warning (subject is too bright). • In P mode, use ND filtre. • In S mode, select faster shutter speed. • In A mode, select smaller aperture (larger fnumber). (If the warning indication remains after performing above remedies in S or A mode, use ND filtre as well.) 50-55 52 54 Lo appears • Underexposure • In P mode, use flash. warning (subject is too • In S mode, select slower dark.). shutter speed. • In A mode, select larger aperture (smaller f- number). (If the warning indication remains after performing above remedies in S or A mode, use flash as well.) 50-55 52 54 Electronic • Subject brightness is • When the subject is bright, 57 analog exposure beyond camera's use ND filtre and when the display blinks exposure range. subject is dark, use flash. The electronic analog exposure display remains blinking when the Speedlight is used. buLb blinks • Shutter speed is set to • Cancel the buLb by 52, 65 buLb in S mode. selecting 30 sec. or faster shutter speed, or select M mode to perform Long Time Exposure. 102 LCD panel Shutter speed indication blinks - Err blinks o-- and frame counter blink Viewfinder Cause Remedy Page 125 appears • Shutter speed faster • Release the shutter as it 82 than sync speed is is to take a flash picture. selected in S or M (Shutter speed mode. automatically shifts to 1/125 sec.) fi blinks for 3 sec. after flash • Flash has fired at full output and underexposure may have occurred. • Shoot again after 79, 83 confirming focus distance, aperture or flash shooting distance range. Err blinks • Malfunction detected. • Release shutter again. If the warning indication remains, or this warning appears frequently, contact authorised Nikon dealer or service centre. o-- and • Camera back is frame counter opened during film blink rewind. •Close the camera back 36 immediately and restart rewinding film by pressing the two „ buttons. In certain cases, due to static electricity or poorly loaded batteries, the F80/F80D/F80S's microcomputer may turn the camera off, even with fresh, properly installed batteries. For the same reason, the film may not advance properly. In each of these cases, to resume operation, simply turn the power off, then turn it on again. Or, remove and reinstall the batteries. 103 Miscellaneous