Nokia 8850 User Guide - Page 10
Signal Strength Affecting Cellular Transmissions, Troubleshooting
View all Nokia 8850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
3.4 SIGNAL STRENGTH AFFECTING CELLULAR TRANSMISSIONS When you are sending a fax, data, or an SMS message, you need to be in an area with network coverage. Cellular connections can be made from most locations where your mobile phone operates. Cellular networks differ from landline networks in many ways, for example, traffic loads and the strength of radio signals may vary in a cellular network and cause handovers. lt is recommended that you move the phone to a location where the strongest possible cellular signal can be obtained. When the signal is strong, cellular transmission is efficient. 4. TROUBLESHOOTING Read the README file included in the Windows Program Group of the PC Suite for Nokia 8850. This chapter points out the basic problems that could occur when you are installing the program. Below you will find a list of symptoms and possible actions you can take if you are in any of the following situations. Setup will not run properly and returns an Error Message stating that the operating system is not appropriate. The PC Suite for Nokia 8850 is only compatible with Windows 2000/XP. The Setup program does not start properly or is not completed. It is recommended that you have 8 MB of RAM in your system, and at least 9 MB of free disk space. Close all unnecessary Windows programs before starting Setup. Also make sure that there are no MS-DOS programs running in the Windows DOS Prompt. Not enough disk space for installation. There is not enough space for completing the installation on the drive you have selected. Select another drive for installation or delete unnecessary files to free additional disk space. lf you have several hard disk drives in your system and you decide to install the program on a drive other than the one where your Windows system files are located, disk space is still required on both drives. The program will always need to place some files in your Windows directory. Setup does not accept the destination directory you have typed in. The program can only be installed to a local drive. Check if the directory where you are trying to install the program is a READ ONLY directory. Select another directory or change the settings of the directory in Explorer (File/Properties Attributes Window - Read Only setting). 7/9