NordicTrack 2950 Instruction Manual - Page 8

3. Insert the fan wire (A) into the left Upright (84). Next, slide the Left Base Cover (89) onto the left Upright (84), and slide the Right Base Cover (90) onto the right Upright. Tip: You may need to use a standard screwdriver to pull the Left Base Cover away from the left Upright so that the Left Base Cover will slide over the welded plate (B). Next, press the Base Covers downward until they snap into place. Next, slide the Upright Covers (141) onto the Uprights (84) until they snap into place. Then, remove and save the four 5/16" x 3" Screws (88) and 5/16" Star Washers (8). 3 88, 8 141 A B 84 89 141 88, 8 84 90 4. Identify the left Tray Bracket (76), which has an attached tie (C). 4 IMPORTANT: To avoid damaging the Tray Bracket (76), do not use power tools. Attach the left Tray Bracket (76) to the left Upright (84) with two #8 x 3/8" Machine Screws (142) and two #8 Flat Washers (23). IMPORTANT: See the inset drawing. Make sure that the Tray Bracket is attached with the Machine Screws through the indicated holes. Attach the right Tray Bracket (76) as described above. Note: There is not a tie on the right Tray Bracket. See the inset drawing. Pull the end of the fan wire (A) out of the left Upright (84). 8 76 C 142 76 23 142 84 23 84 A 76 C 23 142