NordicTrack Apex 4500 Treadmill English Manual - Page 6

ASSEMBLY Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, some lubricant may be transferred to the top of the walking belt or the shipping carton. This is normal and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. Assembly requires the included hex key , a Phillips screwdriver , and wire cutters . For help identifying the assembly hardware, see the drawings below. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it has been preassembled. To avoid damaging plastic parts, do not use power tools for assembly. Extra hardware may be included. Star Washer (67)-4 Screw (7)-2 1" Tek Screw (82)-4 Base Plate Bolt (77)-3 Handrail Bolt (72)-4 1. With the help of a second person, tip the Uprights (20) down as shown. Attach the four Base Pads (81) to the bottom of the Uprights (20) with four 1" Tek Screws (82) in the locations shown. 1 82 81 81 82 82 81 20 82 81 6