NordicTrack C2255 Treadmill User Manual - Page 7

2. Insert the other Extension Leg (97) into the indicated bracket on the base of the Uprights (85) as shown. Attach the Extension Leg (97) with two Extension Leg Bolts (87), two Star Washers (67), and two Extension Leg Nuts (91) as shown. Firmly tighten the Extension Leg Bolts. 2 87 67 Bracket 91 97 85 3. Attach the four Base Pads (81) to the base of the Uprights (85) in the indicated locations with four 3 1" Tek Screws (82) and four Plastic Washers (101). Note: One replacement Base Pad may be included. Use the Base Pad to replace any Base Pad that becomes worn. With the help of a second person, carefully tip the treadmill down so that the Base Pads (81) are resting on the floor and the Uprights (85) are in the vertical position. 101 81 82 101 85 101 81 82 101 4. Remove the band securing the Upright Wire Harness (73) to the right Upright (85). Have a second person hold the console assembly near the right Upright. 4 Console Assembly Connect the Upright Wire Harness (73) to the wires extending from the console assembly. Make sure to connect the connectors properly (see the inset drawing). The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert the connectors into the right Upright (85). 73 85 73 7