NordicTrack E 2500 Treadmill English Manual - Page 7
Note: A replacement Base Pad 99 may be included. Use
View all NordicTrack E 2500 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
4. With the help of a second person, carefully tip the Uprights (69) down as shown. Make sure that the Extension Legs (102) remain in the Uprights. Attach each Extension Leg (102) with two 1" Screws (26) and a Base Pad (99) as shown. Note: Attach the lower Screw (without the Base Pad) first. With the help of a second person, carefully tip the Uprights (69) back to the vertical position. Note: A replacement Base Pad (99) may be included. Use the Base Pad to replace any Base Pad that becomes worn. 5. Insert a Handrail (66) into each side of the console assembly. Note: It may be helpful to twist the Handrail as you insert it. Cut the tie securing the Upright Wire Harness (98). Have a second person hold the console assembly near the Uprights (69). Connect the Upright Wire Harness to the wires extending from the Console Base (81). The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. Insert the connectors and the Upright Wire Harness down into the right Upright, and then set the console assembly on the Uprights. Be careful not to pinch the wires. 6. Insert two Handrail Bolts (78) with 5/16" Star Washers (77) into the right Upright (69) and the right Handrail (66) Be careful not to damage the Upright Wire Harness (not shown). Next, lift the right Handrail slightly and align the Bolts with the holes in the Handrail. (Note: If necessary, twist the Handrail to align the holes in the Handrail with the Bolts). Thread the Bolts into the Handrail. Do not tighten the Bolts yet. Attach the left Handrail (not shown) in the same way. Then, tighten all Handrail Bolts (78). Note: There are no wires on the left side. 7. Attach the Upper Handrail (142) to the Uprights (69) with two 3" Bolts (17) and two Handrail Washers (19) as shown. Firmly tighten the Bolts. 4 69 99 102 26 99 102 26 5 81 98 66 6 69 Console Assembly 69 66 7 142 77 78 8. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 28). To protect the floor or carpet from damage, place a mat under the treadmill. 69 19 17 17 7