NordicTrack E5vi Elliptical User Manual - Page 10

8. Identify the Right Handlebar (10), which is marked with a "Right" sticker, and orient it as 8 shown. Have a second person hold the Right Handlebar (10) near the right side of the Upright (5). Locate the indicated wire tie in the Upright (5). Tie the lower end of the wire tie to the Pulse Wire (34) inside the Right Handlebar (10). Next, 11 pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie. Tip: Avoid pinching the Pulse Wire (34). Attach the Right Handlebar (10) to the Upright (5) with two M8 x 16mm Patch Screws (102) and two M8 Split Washers (103). Attach the Left Handlebar (11) in the same way. 9. The Console (33) can use four D batteries (not included); alkaline batteries are recommended. IMPORTANT: If the Console has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries. Otherwise, you may damage the console displays or other electronic components. Remove the screw, remove the battery cover, insert the batteries into the battery compartment, and reattach the battery cover. Make sure to orient the batteries as shown by the diagram inside the battery compartment. To purchase an optional AC adapter, contact the store where you purchased this product or call the telephone number on the cover of this manual. To avoid damaging the console, use only a manufacturer-supplied AC adapter. Remove the battery cover, remove the batteries, and plug one end of the AC adapter into the jack inside the battery compartment on the console; plug the other end into an outlet installed in accordance with all local codes and ordinances. Route the wire on the AC adapter through the slot in the battery cover and reattach the battery cover. 9 Screw Batteries 33 Avoid pinching the Pulse Wire (34) Wire Tie 34 5 10 103 102 Slot Battery Cover Batteries Jack 10