NordicTrack Incline Trainer X9i Treadmill English Manual - Page 27

Touch the Passcode button. To enable a passcode, touch the Enable checkbox. Then, enter a 4-digit passcode of your choice. Touch Save to use this passcode. Touch Cancel to return to the equipment settings mode and not use a passcode. To disable the passcode, touch the Disable checkbox. Note: If a passcode is enabled, the console will regularly ask for you to enter the passcode. The console will remain locked until the correct passcode is entered. IMPORTANT: If you forget your passcode, enter the following master passcode to unlock the console: 1985. 12. Exit the equipment settings mode. To exit the equipment settings mode, touch the back button on the screen. To avoid damaging the incline trainer, do not turn off the power or remove the key while the firmware is being updated. The screen will show the progress of the update. When the update is complete, the incline trainer will turn off and then turn back on. If it does not, press the power switch into the off position. Wait for several seconds, and then press the power switch into the reset position. Note: It may take a few minutes for the console to be ready for use. Note: Occasionally, a firmware update may cause your console to function slightly differently. These updates are always designed to improve your exercise experience. 4. Calibrate the incline system of the incline trainer. HOW TO USE THE MAINTENANCE MODE The console features a maintenance mode that allows you to update the console firmware, calibrate the incline of the incline trainer, view machine information, and view a button’'s keycode. 1. Select the settings main menu. See step 1 on page 26. Touch the Calibrate Incline button. Then, touch the Begin button to calibrate the incline system. The incline trainer will automatically rise to the maximum incline level, lower to the minimum incline level, and then return to the starting position. This will calibrate the incline system. Press the Cancel button to return to the maintenance mode. When the incline system is calibrated, touch the Finish button. IMPORTANT: Keep pets, feet, and other objects away from the incline trainer while the incline system is calibrating. In an emergency, pull the key from the console to stop the incline calibration. 2. Select the maintenance mode. 5. View machine information. In the settings main menu, touch the Maintenance button to enter the maintenance mode. The maintenance mode main screen will show information about the model and version of the incline trainer. 3. Update the console firmware. For the best results, regularly check for firmware updates. Touch the Machine Info button to view information about your incline trainer. After you view the information, touch the back button on the screen. 6. Find keycodes. The Keycodes button is intended to be used by service technicians to identify whether a certain button is working correctly. 7. Exit the maintenance mode. Touch the Firmware Update button to check for firmware updates using your wireless network. The update will begin automatically. To exit the maintenance mode, touch the back button on the screen. 27