NordicTrack Mtn 750 English Manual - Page 16
Trouble-shooting And Maintenance
View all NordicTrack Mtn 750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
TROUBLE-SHOOTING AND MAINTENANCE Inspect and tighten all parts of the stepper regularly. The stepper can be cleaned with a soft cloth and a small amount of mild, non-abrasive detergent. Keep liquids away from the console. HOW TO ADJUST THE REED SWITCH For the console to display correct feedback, the pedals must move at least five inches with each step. If the console displays incorrect feedback when the pedals are moved five inches or more, the Reed Switch (56) should be adjusted. 52 97 56 46 8 Turn the Flywheel (46) until the Magnet (97) is aligned with the Reed Switch (56) (refer to the inset drawing). Loosen the indicated Screw (52). Slide the Reed 65 Switch slightly closer to the Flywheel, and retighten the Screw. Make sure that the Magnet will not hit the Reed Switch when the Flywheel turns. Repeat until the console displays correct feedback. 26 Carefully slide the Right Side Shield (8) back onto the stepper. Reattach the three M4 x 38mm Screws (64) 64 and the two M4 x 25mm Screws (65). Reattach the 13 Pedal Bracket (13). Remove the right Pedal Bracket (13) by removing the two M10 x 82mm Button Bolts (26) and the two M10 Nylon Locknuts (not shown). Then, remove the two M4 x 38mm Screws (64) and the three M4 x 25mm Screws (65). Carefully slide the Right Side Shield (8) off the stepper. HOW TO LEVEL THE STEPPER If the stepper does not sit level on the floor, turn one or both of the Feet (15) under the Stabilizer (2) until the stepper is level. 2 15 16