NordicTrack S22i Studio Bike Instruction Manual - Page 30
Maintenance And Troubleshooting
View all NordicTrack S22i Studio Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
MAINTENANCE AND TROUBLESHOOTING MAINTENANCE Regular maintenance is important for optimal performance and to reduce wear. Inspect and properly tighten all parts each time the studio cycle is used. Replace any worn parts immediately. To clean the studio cycle, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. CONSOLE TROUBLESHOOTING If the console does not turn on, make sure that the power cord is fully plugged in and that the power switch is in the reset position. If you are having problems connecting the console to a wireless network or if you are having problems with your iFit account or iFit workouts, go to support.iFit.com. people. First, unplug the power cord and press the power switch. Next, locate the small reset opening (A) A near the USB port on the console. Using a bent paper clip, press and hold the reset button inside the open- ing, and have a second person plug in the power cord and press the power switch. Continue holding the reset button until the console turns on. When the reset oper- ation is complete, the console will turn off and then turn back on. If it does not, press the power switch off and then on again. Once the console turns on, check for firmware updates (see HOW TO CHANGE CONSOLE SETTINGS on page 26). Note: It may take a few minutes for the console to be ready for use. INCLINE SYSTEM TROUBLESHOOTING If the frame does not move to the correct incline level, see HOW TO CHANGE CONSOLE SETTINGS on page 26 and calibrate the incline system. If the Console (10) does not stay in place when it is moved to the desired position, tighten the indicated M8 Locknut (99) slightly until the Console stays in place. HOW TO ADJUST THE LEFT CRANK ARM If the Left Crank Arm (21) feels loose while you are pedaling, tighten the two M6 x 25mm Screws (96). 10 99 96 96 21 If the console does not boot up properly, or if the console freezes and does not respond, reset the console to the factory default settings. IMPORTANT: Doing this will erase all custom settings you have made to the console. Resetting the console requires two 30