NordicTrack Sl710 English Manual - Page 6

2. While another person lifts the rear of the Frame (1), attach the Rear Stabilizer (16) to the Frame with four M8 x 40mm Button Screws (54) and four M8 Split Washers (55). 2 1 16 3. While another person holds the Upright (2) in the position shown, connect the Upper Wire Harness (51) to the Lower Wire Harness (43). Gently pull the upper end of the Upper Wire Harness to remove any slack from the Wire Harnesses. Insert the Upright (2) into the Frame (1). Be careful to avoid pinching the Wire Harnesses (43, 51). Attach the Upright with two M10 x 118mm Button Screws (78), two M10 Split Washers (88), and two Upright Spacers (77). Make sure the concave end of each Upright Spacer is turned toward the Upright. 55 55 54 54 3 2 78 88 77 51 43 77 Make sure the wire harnesses do not get pinched and 1 damaged during this step. 4. Identify the Left Handlebar (70), which is marked with an "L" sticker. While another person holds the Left Handlebar near the Upright (2), connect the left Pulse Sensor Wire (6) to the Pulse Wire (3). Next, slide the Left Handlebar onto the indicated tube on the Upright. Be careful to avoid pinching the Wires. Carefully insert two M8 x 40mm Button Bolts (81) through the Left Handlebar and the tube on the Upright. Be careful not to damage the Wires with the Button Bolts. Finger tighten two M8 Nylon Locknuts (89) onto the Button Bolts. Next, slide the Handlebar Collar (85) onto the upper end of the Left Handlebar. Attach the Right Handlebar (72) as described above. Note: As you slide the Right Handlebar onto the right tube on the Upright (2), insert the upper end of the Right Handlebar into the Left Handlebar (70). Connect the Handlebars (70, 72) with the Handlebar Collar (85) and an M4 x 16mm Screw (57). Tighten the four M8 x 40mm Button Bolts (81). Make sure the M8 Nylon Locknuts (89) are seated in the hexagonal holes in the Handlebars. 6 4 Make sure the wires do not get damaged during this step. 2 Tube 81 3 6 70 89 72 85 57