NordicTrack Sl710 English Manual - Page 8

8. Attach the Backrest (62) to the Backrest Frame (42) 8 with two M6 x 20mm Button Screws (20), an M6 x 62 38mm Button Screw (80), and an M6 Washer (60). Slide the Backrest Frame (42) onto the Seat Frame (7). Attach the Backrest Frame with four M8 x 25mm Button Screws (79) and four M8 Split Washers (55). 55 79 42 55 79 60 80 20 7 9. Identify the Left Pedal (22), which is marked with an 9 "L." Using an adjustable wrench, firmly tighten the Left Pedal counterclockwise into the Left Crank Arm (24). Tighten the Right Pedal (not shown) clockwise 25 into the Right Crank Arm. Important: Tighten both Pedals as firmly as possible. After using the exer- cise cycle for one week, retighten the Pedals. For best performance, the Pedals must be kept tight- ened. 24 22 Identify the Left Pedal Strap (25), which is marked with an "L." Attach the Left Pedal Strap to the Left Pedal (22), and adjust it to the desired position. Attach and adjust the Right Pedal Strap (not shown) in the same way. 10. The Console (4) requires four "D" batteries (not 10 included); alkaline batteries are recommended. Slide the battery cover off the Console. Insert four batteries into the battery compartment. Make sure that the batteries are oriented as shown by the diagram inside the battery compartment. Slide the battery cover back onto the Console. Note: When the batter- ies are installed correctly, the fan will turn on for a moment. Battery Cover 4 Batteries 11. Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor. 8